OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U048B

Invalid Data Received From Headlamp Leveling Control Module B

U048B concerns the second headlamp leveling control module, B, whose messages reach the receiver but are discarded as corrupt or implausible; if B fell silent, U018A would be logged, while module A has U0482 and U0181. A second address is needed where each headlamp carries its own electronics or a central unit works with lamp-side controllers. No maker assigns the letter publicly or documents U048B. Comparable lamp-side faults appear under brand codes: Mazda's AFS control module on the 2024 CX-90 falsely flagged B10A3:86, an error signal from the left swivel actuator, until new software arrived (09-039-24), and GM had the headlamp control module of the 2016 Buick Cascada set up again to clear B101E and a leveling warning (16-NA-044). Expect a lighting warning; no MIL.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 8B

Possible causes

  • Software of the lamp-side or leveling module misjudging actuator feedback medium
  • Setup or configuration of the headlamp module not completed after assembly or replacement medium
  • Moisture or poor contact at the connector of the second headlamp low

Symptoms

  • Headlamp leveling or adaptive lighting warning
  • Beam height on one side no longer adjusted

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U048B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication