OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U046E

Invalid Data Received From Exhaust Gas Sensor Module B

U046E points to the B unit among exhaust gas sensor modules, a second smart device that warms a probe in the exhaust, interprets its signal, typically from a wide-band oxygen or NOx sensor, and transmits readings and readiness as bus data. The engine or aftertreatment controller sets it when frames still arrive but fail checksum or counter tests, or values such as NOx level or the ready flag are not credible. Which probe is B is up to the maker, often the one behind the SCR catalyst. No manufacturer documents U046E publicly. Chrysler bulletin 25-002-14 shows such a module on Cummins 6.7 L Ram heavy-duty pickups, there with its lost-contact code U011A. CARB counts these sensors as emission monitors that must be checked for rationality. Expect the MIL and urea dosing or mixture control on defaults. U041B is module A, U016D lost contact.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 6E

Possible causes

  • Heat-damaged or corroded connector and harness at the sensor module high
  • Aged or contaminated probe making the module report implausible values medium
  • Calibration mismatch after replacing the sensor module medium
  • Internal electronics fault in exhaust gas sensor module B low

Symptoms

  • Check engine lamp on
  • Exhaust aftertreatment or emission warning
  • Higher fuel or urea consumption from substitute values

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U046E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication