OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U045F

Invalid Data Received From Automated Driving System Interface Module A

Interface module A sits between an automated driving computer and the base vehicle: it turns the computer's steering, braking and propulsion requests into commands the vehicle's own controllers accept and reports their state back. Bosch places this act layer at the end of its sense-think-act chain. U045F is set when the automation computer or an actuator controller receives frames from interface A that fail checks such as alive counter, CRC or timing, the mechanisms AUTOSAR standardises for end-to-end protection; U015E means interface A is no longer heard. No manufacturer documents U045F publicly. Since the computer can no longer trust what reaches the actuators, it must disengage or, at higher SAE J3016 levels, bring the car to a minimal-risk stop and hand back to the driver. Manual driving remains possible.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 5F

Possible causes

  • Software of interface module A not matching the automation computer or actuator controllers high
  • Connector, bus wiring or supply fault at interface A medium
  • Internal fault of interface module A low

Symptoms

  • Automated driving or advanced assistance refuses to engage
  • Takeover request or warning to the driver

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U045F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication