U044C
Invalid Data Received From Hybrid/EV Battery Inductive Charging Module
U044C covers the module that controls inductive charging of the high-voltage battery: a receiver coil and electronics on the vehicle take energy from a ground pad without a cable and must agree with the charger on alignment, power and battery limits. A receiver such as the battery or vehicle controller stores U044C when the module's frames arrive but hold invalid status or power values; U014B is lost contact. No manufacturer documents U044C publicly. BMW ran such a system as a field test with 200 530e iPerformance cars in California (SIB 61 23 19), with a ground pad module paired over WLAN, and only a few dealers equipped to diagnose it. The likely result is an interrupted or refused wireless charge, while charging by cable and driving normally remain possible.
Possible causes
- Poor alignment or disturbed link between vehicle unit and ground pad medium
- Software of the inductive charging module not matching the battery controller medium
- Internal fault or overheating of the inductive charging module low
Symptoms
- Wireless charging does not start or stops early
- Charging system message in the display
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U044C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.