OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0442

Invalid Data Received From ECM/PCM B

ECM/PCM B stands for a second engine or powertrain controller where a car carries more than one such unit; U0442 means its frames reach a receiver with invalid content, while U0115 means they stop arriving. Mazda applies the code in its own way: bulletin 01-015/18 for the 2018 Mazda6 and CX-5 and the 2019 CX-3 and MX-5 describes the TCM of automatic models flagging invalid PCM data, together with P061B and U0401, when the driver lets go of the brake during cranking. The PCM then enters a fail-safe mode with limited engine speed, and new PCM software cures the false detection. Mercedes-Benz lists U044287 with U014687 when a software conflict in the 48 V battery switches on the check engine light (LI54.21-P-078926). Expect the MIL and, depending on design, reduced power.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 42

Possible causes

  • Control logic in the engine or powertrain software too sensitive, update available high
  • Software levels of sending and receiving units do not match after an update medium
  • Bus wiring, connector or supply fault at the second powertrain controller low

Symptoms

  • Check engine light on
  • Fail-safe mode with limited engine speed or lack of power
  • Transmission codes stored alongside engine codes

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U0442

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication