U043E
Invalid Data Received From Vacuum Sensor A
Vacuum sensor A reports the vacuum in a brake booster or vacuum reservoir; U043E is meant for designs in which this sensor sends digital messages and a receiver judges them invalid. No manufacturer documents U043E publicly. GM's usual layout uses an analogue booster vacuum sensor with P-codes: bulletin 17-NA-314 for 2018 Enclave and Traverse traces a Service Power Brake Assist message and brake shudder to wrong readings from a faulty sensor circuit board, setting P0557 and C025E, and 16-NA-366 for 2014-16 Encore links a hard pedal and a constantly running vacuum pump to contamination in sensor, check valve and hose. Comparable effects are plausible with U043E: brake assist warnings, a longer running vacuum pump or start-stop held off. U013D is lost contact; sensor B has U043F.
Possible causes
- Faulty sensor electronics giving wrong vacuum values medium
- Oil or dirt in the sensor, check valve or vacuum hose medium
- Poor terminal tension at the sensor connector low
Symptoms
- Brake assist warning message
- Hard brake pedal or vacuum pump running often
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U043E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.