OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0437

Invalid Data Received From Differential Control Module - Rear

The rear differential control module runs an electronic limited-slip differential or the rear clutch of an on-demand all-wheel drive. U0437 is set when a receiver gets its frames but finds torque, clutch state or counter values invalid. No manufacturer documents U0437 publicly with thresholds. GM bulletins show how the module is organised: PI1074B links a Service All Wheel Drive message with U0136 in the brake module of 2014 Enclave, Traverse and Acadia AWD to the software of the K47 rear differential module, whereas on 2020 CT5 and Corvette the eLSD logic runs inside the brake controller (20-NA-217) and no separate module exists. Jeep's 2013-14 Grand Cherokee has its own ELSD module (21-001-14). Typical result: AWD or eLSD switched off and a service message. U0136 is lost contact.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 37

Possible causes

  • Rear differential module software needs reprogramming high
  • Corrosion at the module mounted on or near the rear axle medium
  • Faulty clutch actuator or motor feeding implausible status low

Symptoms

  • Service AWD or rear axle message
  • All-wheel drive or limited-slip function inactive

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U0437

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication