OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0436

Invalid Data Received From Differential Control Module - Front

U0436 concerns the front differential control module, a controller that locks or meters the front axle differential, for example the electric locker of an off-road vehicle. A receiver records the code when lock status, clutch torque or diagnostic frames from this module look implausible. No manufacturer documents U0436 publicly. Why trustworthy lock data matters is shown by Mercedes-Benz recall 20V-090 on 2019-20 G-Class: a resistor in the locking module's control unit could be degraded by sulfur from the axle oil, the measured current came out too high and the lock state could not be determined with certainty, so ABS and ESP were deactivated. Expect the front locker or torque split to be disabled and a warning in the cluster. U0135 is lost contact; the rear unit has U0437.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 36

Possible causes

  • Fault in the locking module electronics, e.g. degraded measuring resistor medium
  • Corroded or damaged harness and connector near the front axle medium
  • Differential module software mismatch low

Symptoms

  • Front locker or 4WD function unavailable
  • ABS, stability or drivetrain warning

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U0436

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication