Network
generic / SAE
U042B
Invalid Data Received From Chassis Control Module A
A receiving module detected implausible data from chassis control module A. Vehicle dynamics, ride-height or damper command values fail plausibility checks and are rejected.
SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 2B
Possible causes
- Module internal fault or sensor input drift high
- Software version mismatch after replacement medium
- Gateway module routing CAN messages incorrectly low
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
- Estimated cost: 200–2000 €
- Estimated time: 0.5–4 h
- Component: chassis module a
- MIL / check engine light
- drive cycle required
- limp mode possible
Sources
References
sae:J2012