OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0428

Invalid Data Received From Steering Angle Sensor Module

U0428 is for a separately networked steering angle sensor module, usually on the column, feeding angle and rate to stability control, assistance and stop-start. GM's 2025 brake module counts wrong checksums or counters in its frames (8 of a 16 window) and reacts at once to a cleared validity bit or a data mask stuck at zero, all Type C without MIL. Where the angle comes from the steering gear, GM files a similar data mask fault under U0420. Mitsubishi's 2019 Outlander PHEV sets U0428 in the PHEV-ECU on a failed sensor signal; after the CAN check and data item 333 it asks for calibration and a steering angle offset reset. Jeep cured U0428 with MIL and early engine stops in stop-start on the 2017 Cherokee 3.2 L by PCM software (18-013-17). Audi fixes U042800 on dynamic steering by software (2049656/1). U0126 is lost contact.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 28

Possible causes

  • Steering angle sensor not calibrated after replacement or alignment work high
  • Software in the engine, brake or steering controller misjudging the sensor data medium
  • Steering angle sensor module faulty medium

Symptoms

  • Stability control or steering warning lamp
  • Stop-start stops the engine at the wrong moment or stays off
  • Check engine light on some vehicles

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U0428

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication