OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0425

Invalid Data Received From Auxiliary Heater Control Module

U0425 concerns the auxiliary heater control module, the controller of an extra heat source such as a fuel-fired coolant heater on a diesel. The HVAC or engine controller sets it when the heater's status frames arrive with implausible content. No manufacturer documents U0425 publicly; GM's 2013 bulletin PIP5094 merely includes it in a long list of codes for which terminal fit should be checked before circuit tests. Ford's patent US 10,124,649 shows how such a heater is tied into the network: it talks to the HVAC unit over the bus and to the engine controller through a bus interface, receives ambient temperature from it and runs its own fuel pump. GM's 6.6 L Duramax ECM (2014) watches messages from this module, stating lost contact as U0166, Special Type C. U0325 is software. The heater stays off; no MIL is expected.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 25

Possible causes

  • Auxiliary heater control unit faulty or locked after an internal fault medium
  • Low supply voltage at the heater, for example from a weak battery medium
  • Loose terminals or corrosion in the heater's bus connector low

Symptoms

  • Auxiliary or parking heater does not start
  • Slow warm-up and weak cabin heat in cold weather

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U0425

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication