OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0414

Invalid Data Received From Four-Wheel Drive Clutch Control Module

U0414 is set when a listener, usually the engine controller, receives frames from the four-wheel-drive clutch control module but cannot trust what they carry. That module regulates an on-demand coupling feeding torque to the secondary axle and reports its state on the bus. GM's 2025 ECM tables (25OBDG03B) test the secondary-axle signal every 12.5 ms for faulty rolling counters, protection values or checksums; 8 errors among 18 checks, with at least 11 V and 5 s of stable operation, record a Type B fault, which lights the MIL on a second faulty trip. Ford's 2014 code interpretation also marks U0414 as a MIL code. Lost contact with the module is U0114, a software mismatch U0314. Expect an AWD warning and drive on the primary axle until the data are valid again.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 14

Possible causes

  • Four-wheel-drive clutch module sends faulty values (internal fault, moisture) medium
  • Disturbed CAN traffic from connectors, wiring or low supply voltage medium
  • Clutch module and receiver on software levels that do not match low

Symptoms

  • AWD or 4WD warning in the cluster
  • Drive on the primary axle only
  • Check engine light after two trips

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0414

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication