OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0410

Invalid Data Received From Fuel Pump Control Module

U0410 means the engine controller receives data from the fuel pump control module that it cannot trust, such as a bad checksum, counter or an out-of-range value. Many cars drive the in-tank pump through such a module to set the low-side pressure on demand. GM shows why the data matter for emissions: bulletin PIP5427 (2014-2016 trucks and SUVs) traces a lit service engine lamp and a fuel pressure deviation P2635 to communication faults between ECM and pump module, logged there as U0074 or GM's own U18A2. From 2014 GM renamed this unit chassis control module. No manufacturer documents U0410 publicly. Expect a MIL, hesitation or reduced power. U0109 means lost contact, U0310 a software mismatch.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 10

Possible causes

  • Damaged bus wire or corroded connector to the fuel pump module (often near the tank) high
  • Poor power or ground of the fuel pump module medium
  • Pump module and ECM software do not match after replacement medium
  • Fuel pump control module internally faulty low

Symptoms

  • Check engine light on
  • Fuel pressure codes such as P2635 set together
  • Hesitation, stalling or reduced power

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U0410

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication