U040F
Invalid Data Received From Reductant Control Module
On a diesel with SCR, the reductant control module looks after the urea circuit, chiefly the pump, dosing and heater control, and reports pressure and status to the engine controller. U040F means its messages arrive but fail validation. GM's 2025 ECM tables check counter and checksum of the DEF information and dosing status frames, count 6 errors among 15 or 3 among 10 checks as a failure; the result is Type A with the MIL on trip one. Ford's 2023 diesel OBD summary groups U040F with the functional test of the reductant pump motor and sets it when the duty-cycle control signal of the pump motor controller leaves the 4 to 96 percent window, next to pump speed, voltage and temperature codes. Without trusted module data dosing is stopped, NOx rises and the inducement strategy may later limit speed. U010E is lost contact.
Possible causes
- Pump motor controller in the reductant module reporting an invalid control signal medium
- Corroded connector or damaged bus line at the tank-mounted module medium
- Software of the reductant module or ECM out of step medium
- Reductant control module internally faulty low
Symptoms
- Check engine light
- DEF/AdBlue warning with countdown to a speed limit
- Further SCR or reductant pump codes stored
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U040F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.