OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U040E

Invalid Data Received From Turbocharger/Supercharger Control Module B

U040E is reserved for a second charger control module, B, on engines that run two separately actuated chargers: twin or sequential turbo layouts, or a turbocharger combined with an electrically driven or clutched supercharger. The engine controller sets it when module B's position or status messages keep coming but are judged invalid. No manufacturer documents U040E publicly, the NHTSA bulletin index has no entry, and thresholds are unknown. A useful check in the workshop is whether U040D is also stored: if only B is affected, its own actuator, connector and line are the first suspects, whereas both together point to the shared bus or the controller. With one charger unverified, boost and torque are usually limited and a MIL is likely, as CARB treats boost control as emission-relevant. U010D is lost contact, U040D module A.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 0E

Possible causes

  • Electronics or position feedback of charger actuator B faulty medium
  • Connector or bus line of module B damaged by heat medium
  • Module B with software that does not match the engine controller low

Symptoms

  • Check engine light
  • Reduced power, especially at higher load

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U040E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication