U040B
Invalid Data Received From Exhaust Gas Recirculation Control Module A
U040B refers to an exhaust gas recirculation system driven by its own electronics on the bus, for example a smart EGR valve actuator that receives position targets and returns its measured position. The code is set when that unit's replies reach the engine controller but fail plausibility or protection checks, so the controller can no longer verify how much exhaust gas flows back. U040B appears in no public manufacturer document and in none of the bulletins indexed by NHTSA. GM's 2025 tables show how such checks work on other emission-related modules: counter, protection value and checksum, a fail ratio such as 8 of 18 samples, then a MIL. CARB requires EGR flow to be monitored, so the code counts as emission-relevant; expect EGR to be switched off, higher NOx and possibly less power. U010A is lost contact, U040C module B.
Possible causes
- Electronics or position sensor of the EGR actuator A delivering implausible values medium
- Heat-damaged connector or bus line at the EGR unit medium
- Software of engine controller and EGR module A out of step medium
- EGR control module A internally faulty low
Symptoms
- Check engine light
- Reduced power or rough idle
- EGR flow codes stored alongside
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U040B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.