OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0408

Invalid Data Received From Throttle Actuator Control Module

U0408 points to messages from the throttle actuator control module that the receiver, usually the ECM/PCM, judges invalid: implausible content, a failed checksum or counter, or a value outside its range. Most vehicles integrate throttle control in the engine controller, so a separate TAC module and therefore this code are uncommon; no manufacturer documents U0408 publicly. Ford's 2012 OBD summary illustrates the U04xx logic with U0401, which the TCM stores when ECM torque or pedal data are faulted. Because the throttle meters intake air, CARB's comprehensive component rules apply, and a MIL together with reduced power or a limp mode is likely. U0107 means lost contact, U0308 a software mismatch with the same module.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 08

Possible causes

  • Damaged bus wire or poor connector contact at the throttle module medium
  • Throttle actuator control module internally faulty medium
  • Software of throttle module and ECM do not match medium
  • Low or unstable supply voltage low

Symptoms

  • Check engine light on
  • Limp mode with reduced throttle response
  • Unstable idle or stalling

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U0408

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication