OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0404

Invalid Data Received From Gear Shift Control Module A

Gear shift control module A is the electronic selector of shift-by-wire cars: lever, dial or buttons that report the chosen range as data. U0404 means its messages still arrive but the receiver, usually the transmission controller, rejects them. GM's 2025 ECM checks counter and protection fields of the selector's position-sensor and self-check signals, fails a signal after 4 errors in 10 or 8 in 18 checks; the code is Type B with two trips. FCA stored U0404 in the TCM of 2016 Durango and Grand Cherokee eight-speeds with MIL and a blinking M on shifter and cluster, cured by TCM software (21-011-16 Rev. A). Audi found U040400 in the gearbox unit of 2021 A6/A7 models with an intermittent selector lever fault message and no range selectable; the gateway J533 needed new software. U0103 means lost contact, U0304 a software conflict.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 04

Possible causes

  • Software of TCM or gateway (update available) high
  • Position sensor or electronics in the selector delivering implausible values medium
  • Connector or bus line at the selector loose or corroded medium
  • Gear shift module internally faulty low

Symptoms

  • Selector fault message or flashing range indicator
  • Range cannot be selected or vehicle stays in Park
  • Check engine light

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0404

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication