Network
generic / SAE
U0403
Invalid Data Received from Transfer Case Control Module
A control module is communicating with the engine ECU but receives data that is implausible or out of range — wrong checksum, value frozen, or value outside expected limits. Typical effects include limp-home and incorrect dashboard readings.
SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 03
Possible causes
- Transfer case internal sensor or processing fault medium
- CAN corruption causing checksum errors medium
- Gateway module routing CAN messages incorrectly low
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
- Estimated cost: 80–1500 €
- Estimated time: 1–5 h
- Component: transfer case control module
- Component: can bus wiring
- MIL / check engine light
Sources
References
sae:J2012