OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0400

Invalid Data Received

U0400 is the unspecific entry of the invalid-data block. It says that a module receives messages from another node on time but rejects their content, without naming the sender; the codes from U0401 upward name the partner. GM's 2011 Saab 9-5 manual handles U0400 to U05FF in one procedure: the receiver doubts the integrity of incoming data, the test runs between 9 and 16 V while the network works, no circuit check is involved, and if the code stands alone the named module is reprogrammed, then replaced. Harley-Davidson shows the usual trigger in bulletin M1720: on 2021-2024 Pan America models, updating only the ECM leaves a U040000 that cannot be cleared, so the BCM must be flashed first. Lost contact is the U01xx block, software conflicts are U03xx. Effects depend on the module that stores it.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number4 / 00

Possible causes

  • Modules on different software levels after a partial update high
  • Replaced module not programmed or configured medium
  • Disturbed bus signal from poor connections or low supply voltage low

Symptoms

  • Code cannot be cleared or returns at once
  • Functions of the storing module limited or warning lamp on, depending on the vehicle

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U0400

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication