U0350
Software Incompatibility With Active Grille Air Shutter Module C
Module C denotes one more flap actuator with its own bus address, needed where the front end splits its air openings into more sections, for example left and right lower flaps. U0350 indicates that the engine controller does not accept this unit's software. No manufacturer documents U0350 publicly. Hyundai's 2026 Palisade shows that a module C exists in practice: it drives the lower air flaps with one actuator per side, and its campaign 26-01-026H names U028B, loss of shutter module C, beside U0285 when water corrodes their connectors; which side carries the letter is not stated. GM's 2024 Traverse case shows that a shutter misreporting because of its firmware is replaced rather than reprogrammed (PIT6133). CARB treats grille shutters as active off-cycle technology. U058C is invalid data. The affected flaps stay fixed.
Possible causes
- Side or lower flap actuator with another part number or firmware fitted high
- Left and right actuators swapped or mixed between model versions medium
- Engine controller software expects a different shutter configuration low
Symptoms
- Air flap warning message in the cluster
- One group of flaps remains in its last position
- Check engine lamp may light depending on the maker
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0350
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.