U0342
Software Incompatibility With Hybrid/EV Battery Interface Control Module I
Mitsubishi shows that a replaced monitoring board must first be given its place in the pack. On the 2022 Outlander plug-in hybrid, numbering of the cell monitoring units (CMU) is done at the factory; after a CMU or battery module has been replaced, the workshop runs CMU ID numbering from the battery management unit with the M.U.T.-III tester, never while the battery is charging, and checks that every ID data item reads complete, repeating the routine otherwise. The same manual names the CMU among probable causes of cell temperature faults. Mitsubishi uses no letter codes here, and the ninth position I presupposes a pack with nine boards. U01A8 is I's lost-contact code, U04A9 invalid data.
Possible causes
- Replaced board not numbered or registered in the battery controller high
- ID numbering run while charging or aborted before completion medium
- Board of another battery variant fitted at position I low
Symptoms
- Battery warning after a module or CMU replacement
- EV mode or charging restricted
- MIL possible on plug-in hybrids
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U0342
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.