U033F
Software Incompatibility With Hybrid/EV Battery Interface Control Module F
Public documents name no vehicle that uses U033F, nor a pack with exactly six interface boards; F is simply the sixth address in the row. What is documented is how strictly battery software must follow the hardware. Hyundai's bulletin 18-HC-003 requires a BMS parameter update whenever a replacement lithium battery is installed in a 2011–2015 Sonata Hybrid or a 2015–2017 Tucson Fuel Cell. FCA cured P1A29, a failure of cell supervisory circuit A on the 2026 RAM 1500 eTorque, with new battery pack control module software (08-282-26); owners had noticed limp-home mode and a disabled stop/start. CARB 1968.2 counts cell voltage sensing among the hybrid inputs OBD must watch. U01A5 and U04A6 are F's partners.
Possible causes
- Battery parameters not updated after a pack or module replacement high
- Board F taken from another pack with a different software level medium
- Battery controller on an outdated calibration low
Symptoms
- Limp-home mode or reduced electric power
- Stop/start or electric assist disabled
- Battery or hybrid warning after battery service
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U033F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.