OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U033D

Software Incompatibility With Hybrid/EV Battery Interface Control Module D

On the first-generation Chevrolet Volt the monitoring electronics end at the fourth board. GM's 2012 Volt table refers to four slave units through its own codes: P1EB2 to P1EB5 report a slave that answered wrongly or not at all when a programming session ended, and U2603 to U2606, listed in GM's U-code catalogue for the 2011 Saab 9-4X as loss of hybrid battery interface control modules 1 to 4, block the software comparison while a slave is silent. A fourth slot exists there, but GM uses its own numbers instead of U033D; in the 2018 table P1EB5 is labelled module D not programmed. A failed flash of that board thus shows up as P1EB5. U01A3 and U02A0 are the generic lost-contact and invalid-data codes for D.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number3 / 3D

Possible causes

  • Programming of the fourth board aborted or answered with an error high
  • Replacement board D still on a superseded software version medium
  • Interrupted link to board D masks or disturbs the version check low

Symptoms

  • Code appears after programming or replacing a battery section
  • Hybrid warning, MIL possible on plug-in hybrids
  • Reduced propulsion until all boards match

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U033D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication