U0337
Software Incompatibility With Battery Charger Control Module A
Battery charger control module A is the charger built into a plug-in car: it turns mains AC into DC for the traction battery and coordinates with the charging station and the battery controller. U0337 appears when a partner module refuses the charger's software or calibration. No manufacturer documents U0337 publicly. Maserati updates the OBCM software on 2025 GranTurismo and Grecale electric models because a charging fault could only be cleared by unplugging and reconnecting (Rapid Update 751). FCA's bulletin 08-048-14 for the 2013–2014 Fiat 500e updated charger, vehicle control unit, inverter and battery controller together, partly to cut 12 V drain on incompatible charging stations. CARB expects plug-in hybrids to monitor charging performance. U019B is lost contact, U049C invalid data. Charging may stop.
Possible causes
- On-board charger left on an older software level after other modules were updated high
- Charger replaced without programming to the vehicle medium
- Charger update interrupted, for example by low 12 V supply low
Symptoms
- Charging does not start or stops after a short time
- Charging fault message that clears only after replugging
- 12 V battery drained after charging sessions
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U0337
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.