U0319
Software Incompatibility With Steering Effort Control Module
U0319 is set when the steering effort control module, the unit that varies steering assist, for example with road speed, reports a software or calibration identity the network does not accept. J2012 keeps it apart from the power steering control module, which has its own code U0320. GM's generic U03xx description fits: the check runs at 9-16 V with normal bus traffic, and a module that was not configured after installation sets the code; the repair is programming, not wiring. No manufacturer documents U0319 publicly, so which steering unit carries the code is maker-specific. U0130 means lost contact, U0419 invalid data from the same module. Steering may feel heavier or less speed-dependent, a steering warning may light, the MIL normally stays off.
Possible causes
- Steering module replaced or flashed without setup high
- Software variant does not match vehicle configuration medium
- Programming aborted or wrong file loaded low
Symptoms
- Steering heavier or assist no longer speed-dependent
- Steering warning light or message
- Code appears after steering module work
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U0319
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.