U0318
Software Incompatibility With Brake System Control Module
U0318 indicates a software or calibration mismatch with the brake system control module, a unit J2012 separates from the ABS module (U0315) and the vehicle dynamics module (U0316). Which box that is depends on the maker; on brake-by-wire systems or electromechanical boosters it is often the controller that builds brake pressure. GM's U03xx procedure (Saab 9-5, 2011) describes the trigger: a module not configured properly, checked at 9-16 V, no external circuit involved. No manufacturer documents U0318 publicly, so the exact owner of the code must come from the vehicle's own manual. It mostly appears after a module swap or a broken flash. U0129 means lost contact, U0418 invalid data. Brake warnings and reduced assist functions are possible; MIL usually off.
Possible causes
- Brake system module replaced or flashed without setup high
- Software level does not match the ABS/ESC or engine controller medium
- Programming aborted due to low battery voltage low
Symptoms
- Brake system warning light or message
- Brake assist or regenerative braking functions unavailable
- Code appears after brake module service
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U0318
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.