U0316
Software Incompatibility With Vehicle Dynamics Control Module
U0316 means the vehicle dynamics control module, the electronic stability control unit, reports a software or calibration identity another module does not accept, typically after it was replaced or reflashed without setup. GM's U03xx procedure (Saab 9-5, 2011) runs at 9-16 V and sets such codes when a module is not configured properly; GM itself uses U0315 for its electronic brake module. Mazda uses U0316 differently: in 2014-2015 Mazda3, Mazda6 and CX-5 bulletins U0316:09 sits in a receiving module and stands for an error signal received from the DSC unit, there caused by a failed SAS module. So on a Mazda it is a follow-up code, not a software issue. U0122 means lost contact, U0416 invalid data. Stability control may switch off; MIL normally off.
Possible causes
- Stability control module replaced or flashed without setup/coding high
- Software variant does not match vehicle equipment medium
- Mazda: fault in DSC or SAS module reported to other units (U0316:09) medium
Symptoms
- Stability or traction control warning light on
- Driver assistance functions unavailable
- Code stored in several modules at once
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U0316
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.