U030D
Software Incompatibility With NOx Sensor A
NOx sensor A is in most layouts the upstream sensor ahead of the SCR catalyst; its own control unit measures NOx and oxygen and sends both on CAN. U030D shows that the engine controller does not accept the software or calibration of this smart sensor, a frequent result of fitting a sensor meant for another engine or model year. Ford's 2014 code interpretation lists U030D with the MIL marker. Ford's 2023 diesel summary also shows how closely these sensors are checked: missing frames from sensor A count after 1 s, and U059E is set when the sensor's calibration verification number does not reach the ECU. CARB requires such a CVN to prove that emission software is valid for the vehicle. SCR dosing and catalyst monitoring depend on this signal, so a MIL is expected. U029D means lost contact, U030E covers sensor B.
Possible causes
- Replacement NOx sensor of another part number or software level fitted high
- Aftermarket sensor whose identification the controller rejects medium
- Engine controller updated to a calibration that expects a newer sensor low
Symptoms
- MIL on, SCR or emission system warning
- NOx and SCR readiness monitors incomplete
- Possible DEF countdown or reduced power on some trucks
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U030D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.