U030B
Software Incompatibility With Glow Plug Control Module 2
U030B is the counterpart of U0307 for a second glow plug control module, used where an engine splits its glow plugs between two drivers, say one per bank. It is stored when the engine controller rejects the software or calibration identity of module 2, typically after only one of the two units was replaced or flashed. No manufacturer documents U030B publicly. A GM patent explains the dialogue behind it: glow plug faults are judged from several messages passed between engine and glow controller, with a strategy that changes with how long the plugs have been on in a drive cycle. GM also asks for the glow module software to be brought up to date after glow plug work (PIP5524). CARB requires glow plugs to be checked for proper response. U019C stands for lost contact, U049D for invalid data. Cold starts suffer; a MIL is likely.
Possible causes
- Only glow module 2 (or only module 1) replaced, software levels now differ high
- Module of another part number or engine variant installed in position 2 medium
- Engine controller updated without the second glow module medium
Symptoms
- Hard cold start, uneven running until warm
- White smoke after starting in the cold
- MIL and glow plug warning on
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U030B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.