OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U030A

Software Incompatibility With Evaporative Emission System Leak Detection Control Module

In some evaporative systems a dedicated module with its own pump or valve, pressure switch and electronics runs the leak test. U030A means that controller has found the module's software or calibration not to fit. No manufacturer documents U030A publicly. Kia's 2017-2019 Niro hybrid uses such a natural vacuum leak detection unit: its lost-communication code U029F00 lit the MIL, and bulletin PS593 traced it to a damaged signal wire at the NVLD connector. Ford's 2014 code interpretation gives U029F the MIL marker as well. CARB demands the leak monitor, so a mismatch that blocks or falsifies it is emission-relevant and a MIL is probable. The car drives normally; the EVAP readiness flag may remain incomplete, which can fail an inspection. U029F is the lost-contact code.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number3 / 0A

Possible causes

  • Leak detection module replaced with a unit of another part number high
  • Engine controller reprogrammed with a calibration that expects other module software medium
  • Damaged signal wire corrupting the identification exchange low

Symptoms

  • MIL on, usually without any drivability change
  • EVAP readiness monitor not completed
  • Further EVAP leak test codes may follow

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U030A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication