OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0308

Software Incompatibility With Throttle Actuator Control Module

U0308 flags that the throttle actuator control module carries software or a calibration that the engine controller does not accept. In most current cars throttle control lives inside the ECM/PCM, so a separate TAC module and this code are rare; no manufacturer documents U0308 publicly. Ford shows how such a mismatch is handled when the logic is integrated: its 2012 OBD summary files a software version mismatch between the electronic-throttle processors under U0300, non-MIL on Gen2 and MIL on Gen3/Gen4 throttle systems. GM's U03xx procedure links these codes to a module that was not configured after installation. Throttle control affects emissions, so CARB demands monitoring and a MIL is likely. U0107 means lost contact, U0408 invalid data.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number3 / 08

Possible causes

  • Throttle or engine control module replaced or flashed without matching software high
  • Wrong or outdated calibration loaded, e.g. by an engine tune medium
  • Programming aborted due to low voltage low

Symptoms

  • Check engine light on
  • Reduced power or limp mode with limited throttle opening
  • Code appears after module replacement or programming

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U0308

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication