OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0306

Software Incompatibility With Fuel Injector Control Module

Some diesels fire their injectors through a separate fuel injector control module that raises the voltage and opens each injector when the engine controller commands it; Ford's 6.0 L Power Stroke used such a FICM at about 48 V, and GM's 2005 Duramax table watches its injector driver by a CAN status bit that must toggle every 20 ms. U0306 means the controllers judge the module's software or calibration as not matching, for example after a used or remanufactured FICM was fitted. Ford's 2014 OBD-II code interpretation carries U0306 without its MIL marker; other makers may rate it differently, because injection timing and quantity decide emissions. U0105 stands for lost contact, U0406 for invalid data. Depending on the strategy the engine runs roughly, drops into reduced power or will not start.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number3 / 06

Possible causes

  • Used, remanufactured or wrong-variant injector module fitted without programming high
  • Engine controller reflashed or replaced while the injector module kept old software medium
  • Programming of the injector module interrupted, e.g. by low battery voltage low

Symptoms

  • Hard start or no start, engine may crank without firing
  • Rough running, misfire or reduced power
  • Further injector or injector module codes stored

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U0306

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication