OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0301

Software Incompatibility With ECM/PCM

U0301 means a module has found that the engine or powertrain controller carries software or a calibration it cannot work with, most often after the ECM was replaced, flashed or coded for another variant. GM's 2011 Saab 9-5 manual lists U0301 as a setup fault: tested between 9 and 16 V while the data link works, triggered by a module left unconfigured after fitting, repaired by programming rather than wiring work. Volkswagen names U0301 on 2013-2018 gasoline models after ECM replacement: both ECM and TCM must be on the latest software, then configured (tip 01-18-10TT). Volvo reports CEM-U030141 after service software downloads on 2015-2019 cars and calls it harmless. As CARB demands a unique CAL ID per emission calibration, the mismatch is emission-relevant; MIL and drivability limits are possible.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number3 / 01

Possible causes

  • ECM/PCM replaced or flashed without configuration high
  • ECM and TCM on different software levels after an update medium
  • ECM coded for the wrong variant or modified by tuning medium
  • Volvo: entry left behind by a service software download low

Symptoms

  • Check engine light or other warning lamps
  • Gearbox or other systems in a restricted mode
  • Code stored in several modules after ECM work

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U0301

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication