OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U02AD

Lost Communication With Turbocharger/Supercharger Boost Control B

A second boost actuator appears on engines with two chargers, either one per cylinder bank or in a staged layout where a high-pressure and a low-pressure stage share the work. BorgWarner's two-stage patent describes a valve that shifts exhaust gradually from the small to the large turbine; its setting decides which stage does the work. U02AD is stored when this B actuator falls silent on the bus while A may still respond. No manufacturer documents U02AD publicly. A Ford two-stage patent shows a typical failsafe: bypass valve fully open, wastegate shut and torque capped so the low-pressure charger cannot overspeed or surge, chiefly at altitude. CARB treats such actuators as monitored boost components. Expect a MIL and limited power.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number2 / AD

Possible causes

  • Damaged plug or harness at actuator B, heat-aged insulation high
  • Supply or ground of actuator B interrupted medium
  • Electronics of actuator B failed medium
  • Replacement actuator not matched or not set up for position B low

Symptoms

  • Check engine lamp
  • Weak pull in the speed range where the second stage normally takes over
  • Engine power limited

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U02AD

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication