OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U02A3

Lost Communication With Particulate Matter Sensor

The particulate matter sensor behind the diesel particulate filter collects soot on a heated element; its own control unit reports the result over CAN, and the engine controller uses it to judge the filter. U02A3 means those frames have stopped. Ford's 2023 diesel summary sets it after 7 s at 11 to 16 V. GM waits 10 s and rates it Type B. Ford's 2014 code list and FCA's Ram 2500 and 3500 bulletin 18-052-19 show it with MIL. FCA STAR case S2218000023 for the 2019 Jeep Compass explains U02A3 right after a sensor replacement by a wrong sensor variant, so compare the stamped part number. On 2023 Volvo and Mack trucks it set when the engine was cranked immediately after key on; new software followed. The filter check stays incomplete, and on trucks a derate is possible.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number2 / A3

Possible causes

  • Wrong particulate sensor variant fitted during repair high
  • Chafed harness, blown fuse or corroded connector at the sensor unit medium
  • Engine control software with start-up timing fault medium
  • Particulate sensor control unit internally failed low

Symptoms

  • MIL on
  • Particulate filter monitor not completed
  • Derate or inducement warning on some trucks

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U02A3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication