OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U02A1

Lost Communication With NOx Sensor C

A third NOx sensor, C, is fitted where the aftertreatment needs one more measuring point, typically behind a second SCR stage. U02A1 is set when its CAN messages no longer reach the engine controller. GM's 2025 tables (25OBDG04B) wait longer than 10 s without any of its five messages, with 11 to 18 V and the bus up, and rate it Type B, so the MIL comes on after the second failed trip; the sibling codes for sensors A and B are Type A there. GM also lists U02A1 in bulletin 21-NA-149 among codes caused by chafed engine harnesses on 3.0 L LM2 diesel trucks and SUVs. Ford's SSM 51750 links it on 2023 F-Super Duty 6.7 L to a harness 14406 rubbing on the EGR cooler near C146; first check 20 A fuse F18. The second SCR stage then goes unchecked.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number2 / A1

Possible causes

  • Engine harness chafed on a hot component such as the EGR cooler high
  • Blown fuse feeding the NOx sensor modules medium
  • Water or corrosion at the sensor C connector medium
  • NOx sensor C control unit internally failed low

Symptoms

  • MIL on after two drives
  • Further NOx or PM sensor codes stored at the same time
  • SCR monitor for the second stage incomplete

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U02A1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication