OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U029F

Lost Communication With Evaporative Emission System Leak Detection Control Module

Some evaporative systems run the leak test through a separate module that holds its own valve, pressure switch or sensor and reports results to the engine controller. U029F is stored when those reports no longer arrive. Kia documents it for the Niro hybrid of 2017 to 2019: bulletin PS593 describes a MIL with U029F00 and, on cars built before October 2018, asks for a resistance check of the yellow signal wire between pin 12 of joint connector EF11 and pin 2 of the natural vacuum leak detection plug F56, since damaged insulation or corroded strands near F56 cause an open circuit. Ford's 2014 code list marks the code as a MIL code. CARB 1968.2 requires gasoline vehicles to find leaks as small as 0.020 inch, so the EVAP monitor cannot run. Driving is not affected.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number2 / 9F

Possible causes

  • Damaged insulation or corroded strands in the module signal wire high
  • Corrosion or water at the leak detection module connector medium
  • Supply or ground of the leak detection module interrupted medium
  • Leak detection module internally failed low

Symptoms

  • MIL on
  • EVAP readiness not set
  • No noticeable change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U029F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication