OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U029D

Lost Communication With NOx Sensor A

NOx sensor A is normally the engine-out or SCR inlet sensor; its control unit puts NOx and oxygen values on CAN. U029D means these frames have stopped. GM treats it as Type A: its 2016 diesel tables wait 10 s, the 2025 tables (25OBDG04A/B) about 1 s for most frames, at 11 to 18 V with the bus otherwise healthy; on the 2014 6.6 L LML the code also counted checksum errors. Ford's 2023 diesel summary allows just over 1 s. Ford found water in the sensor module plug of 6.7 L F-Super Duty trucks from 2017-2019 and replaced module and harness 14406 (TSB 18-2365). Volvo and Mack name fuses, supply, J1939 wiring and terminating resistors, and on 2023 trucks a start-up timing bug. Deutz uses U029D for the upstream SCR sensor. MIL, open SCR checks and derate are possible.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number2 / 9D

Possible causes

  • Water or corrosion in the NOx sensor module connector or harness high
  • Blown fuse, open supply or ground of the sensor module medium
  • Sensor CAN wiring damaged or terminating resistor faulty medium
  • Engine control software with start-up timing fault medium
  • NOx sensor control unit internally failed low

Symptoms

  • MIL on
  • SCR or NOx monitor not completed
  • Engine derate on some trucks

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U029D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication