U0291
Lost Communication With Gear Shift Control Module B
With shift-by-wire, the driver's lever, buttons or dial is an electronic module that sends the selected range to the transmission over the network. Gear shift control module B is a second unit of this kind; U0291 means the transmission controller has stopped receiving its messages. Allison documents the pair for its sixth-generation controls of the 1000 to 4000 series, released in 2021: U0103 covers gear shift module 1, U0291 module 2, with separate codes for incompatibility (U0333) and invalid data (U0592) of the second selector. Mercedes-Benz uses U029100 on the 8-speed dual-clutch transmission 724.1 for a communication fault with the electronic selector lever module. Range changes requested at that selector are then ignored; the transmission typically stays in or returns to a safe range.
Possible causes
- Loose or corroded connector at the second selector high
- Bus line to selector B chafed or interrupted medium
- Selector variant or software not matching the transmission calibration medium
- Selector module B internally failed low
Symptoms
- Gear selection at the selector has no effect
- Transmission warning or flashing range display
- Vehicle cannot be shifted out of Park or Neutral
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0291
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.