OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U024F

Lost Communication With Side Obstacle Detection Control Module D

Module D is the fourth side radar in Ford's scheme beside SODL, SODR and SODCMC. Ford's bulletins list SODCMD among units that log U2100 or U3002 after replacement on 2021–2025 models; SSM 53569 adds that a VIN mismatch can also follow swapping a tail lamp from another car, and that radar modules cannot move between vehicles without programming. Which corner D covers is not published. No maker document uses U024F. It is set by a receiving module once D's frames stay absent. Wiring at the rear deserves a look first: GM found on 2013–2014 Enclave, Traverse and Acadia that the side object sensor harness rubbing on the muffler disturbed the whole LAN and set many U codes (PI1202). The driver sees a side assist warning and the affected zone unwatched. C is U024E; corrupt data from D are U0550.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number2 / 4F

Possible causes

  • Rear radar harness chafed or heat-damaged near exhaust or bumper high
  • Module or tail lamp from another vehicle fitted without programming medium
  • Radar module without power or ground medium
  • Radar module internally faulty low

Symptoms

  • Side assist or blind spot warning message
  • One monitoring zone without alerts

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U024F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication