U0216
Lost Communication With Door Switch B
U0216 reports that door switch unit B has dropped off the network. FCA uses the code on the 2014 Jeep Cherokee (KL) and its text names the driver door switch as the missing partner, so B is the driver's panel there. Bulletin 08-013-15, which replaced 08-111-14 and was also issued as rapid response transmittal 15-021, covers vehicles built up to 11 July 2014: after the battery had been disconnected, the cluster could show Start/Stop Not Available and the BCM held U0216. The cure was new BCM software, followed by restoring and aligning the Proxi configuration whenever the start/stop message had appeared. On other vehicles a wiring fault in the driver door remains the usual suspect. No MIL.
Possible causes
- Outdated BCM software (FCA 2014 Cherokee, bulletin 08-013-15) high
- Vehicle configuration (Proxi) no longer consistent after battery disconnect medium
- Damaged wiring or connector between driver door and body medium
- Driver door switch unit failed low
Symptoms
- Cluster message Start/Stop Not Available
- Code appears after the battery was disconnected
- Keys on the driver's switch panel may not respond
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0216
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.