U0215
Lost Communication With Door Switch A
U0215 is logged when door switch unit A, a keypad with its own small controller, stops answering on the bus. NXP application note AN2205 shows how such a keypad usually works: it is a LIN slave that never speaks unprompted; the body controller asks it roughly every 100 ms and expects a four-byte reply holding key states and LIN error flags. If that reply goes missing, the master records the loss. In the GM manual for the 2011 Saab 9-5 these checks run only between 9 and 16 V, and a history entry is dropped after 50 clean ignition cycles. No manufacturer documents U0215 publicly, and which door carries letter A depends on the maker. U0516 reports invalid data from the same switch. Usually only the keys of one panel fail; no MIL.
Possible causes
- LIN or supply wire broken where the harness flexes at the door hinge high
- Switch unit A without battery feed or ground medium
- LIN line shorted to ground or battery (often silences several nodes at once) medium
- Electronics in switch unit A failed low
Symptoms
- Window, mirror or lock keys on one panel do nothing
- Panel backlighting stays dark
- Code returns after clearing, sometimes only when the door is moved
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U0215
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.