U01AE
Lost Communication With Hybrid/EV Battery Interface Control Module O
U01AE concerns battery interface control module O, which only exists in systems with at least fifteen monitoring nodes; no manufacturer documents the code publicly. Wikipedia distinguishes three ways to organise battery management: centralised (one controller wired to every cell), modular (several controllers, each covering a group of cells) and distributed (a board per cell with a single communication cable). Only the last two need an internal link and thus codes like this one; for modular hardware the article cites a ceiling of 255 nodes, while NXP specifies 63 for one MC33771C chain. With O missing, its section of the pack is unmonitored, and the controller will typically warn, limit power and hold off charging until the board is heard again.
Possible causes
- Internal link to module O interrupted high
- Battery interface control module O defective medium
- Board O without supply from its cell group low
Symptoms
- Warning lamp, power reduced
- Charging postponed or refused
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U01AE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.