OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U01A9

Lost Communication With Hybrid/EV Battery Interface Control Module J

U01A9 stands for battery interface control module J, the tenth board. Apart from wiring, a typical trigger after repairs is configuration: monitoring chips in a chain usually get their address when communication starts. NXP's MC33771C cell controller, for instance, receives its address during initialisation and supports up to 63 nodes per chain, and a Nuvoton patent (US20210184474) describes addresses handed out one after another at start-up in daisy-chained supervisors. A replaced or reordered board that fails to take its slot may therefore go missing for the master. Software mismatch with the same board has its own code, U0342. No manufacturer documents U01A9 with a monitor of its own; GM only lists it in the 2018 bundle BICM Loss of Comm.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number1 / A9

Possible causes

  • Board J not addressed or registered after module replacement medium
  • Chain connection between module I and module J interrupted high
  • Battery interface control module J defective low

Symptoms

  • Code appears right after battery repair or module replacement
  • Vehicle not ready to drive or power limited

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U01A9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication