U01A0
Lost Communication With Hybrid/EV Battery Interface Control Module A
U01A0 names battery interface control module A, the first slave board that reports cell voltages and temperatures of its pack section to the battery controller. GM's 2016-2019 plug-in hybrid tables explain how the code arises: the battery system module talks to eight such boards over a UART daisy chain; once U179C shows that data has stopped, it switches the boards into an internal loopback test and stores the code of the first board it still cannot reach, in 2016 after 5 s above 10.2 V, Type A with MIL on the first trip. Because A sits next to the master, a break ahead of A silences every board in the chain while only A gets named. Audi lists U01A000 for the 2016 A3 Sportback e-tron, which then refuses to make the drive system ready.
Possible causes
- Chain wiring or connector between battery controller and module A interrupted high
- Module A without supply from its cell group or low-voltage feed medium
- Battery interface control module A defective medium
- Chain interface of the battery controller itself faulty low
Symptoms
- Vehicle does not become ready to drive, red hybrid/EV warning
- MIL on after the first failing trip (GM Type A)
- Further module codes or U179C stored at the same time
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U01A0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.