Network
generic / SAE
U019E
Lost Communication With Transmission Range Control Module
ECU lost communication with transmission range control module (PRNDL gear selector). A communication loss with this module breaks any function relying on its data — diagnostic tools may show 'no response' and dependent modules can fall into limp mode.
SystemNetwork
Typegeneric / SAE
GroupU0
Range / number1 / 9E
Possible causes
- Module unpowered high
- Gateway module routing CAN messages incorrectly low
- CAN terminating resistor (120 Ω) drifted out of spec low
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
- Estimated cost: 150–1200 €
- Estimated time: 1–4 h
- Component: transmission range module
- Component: can bus
- MIL / check engine light
- limp mode possible
Sources
References
sae:J2012