Network
generic / SAE
U0188
Lost Communication with Audio Rear Control Module
The Audio Rear Control Module has stopped transmitting on the vehicle data bus, so other control units no longer receive its messages. Rear-seat audio controls stop working. Typical causes are loss of power or ground at the module, an open or shorted CAN/LIN bus wire, a connector fault, or an internal module failure.
SystemNetwork
Typegeneric / SAE
GroupU0
Range / number1 / 88
Possible causes
- Rear audio module unpowered high
- CAN wiring to rear audio module broken medium
- Gateway module routing CAN messages incorrectly low
Symptoms
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
- Estimated cost: 50–600 €
- Estimated time: 0.5–2 h
- Component: audio rear control module
- Component: can bus wiring
Sources
References
sae:J2012