U017F
Lost Communication With Seat Belt Pretensioner Module B
U017F is the second pretensioner module code: module B has dropped off its link to the airbag unit. Audi documents it together with U017E00 in bulletin 2081251 for 2025-26 A5, A6, Q5 and Q6 e-tron models, where both codes accompany a proactive occupant protection warning and dealers are asked to file a case report. Two such modules are typical because each front seat gets its own motorised retractor, as on the 2015 A3 with J854 and J855. Keep U017F apart from Audi's B130474/B130574: those describe a deviating tensioning actuator, not a lost link. If a retractor with control unit was replaced after a collision, Audi requires a basic setting with the scan tool. Pyrotechnic pretensioners are wired separately. No MIL.
Possible causes
- Retractor with control module replaced but not coded or basic-set high
- Supply or bus connector at module B loose medium
- Pretensioner module B internally faulty medium
- Bus line between airbag unit and module B damaged low
Symptoms
- Pre-crash protection fault message in the instrument cluster
- Reversible belt tightening on one seat inoperative
- Often stored together with U017E
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U017F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.