U017E
Lost Communication With Seat Belt Pretensioner Module A
U017E reports that seat belt pretensioner module A no longer communicates. Such modules drive electric, reversible belt tensioners: Audi pre sense pulls the front belts tight by small motors when it senses emergency braking or skidding and releases them if no crash follows. On the 2015 A3, the airbag unit J234 runs the left and right tensioner modules J854/J855 over LIN; the pyrotechnic tensioners are separate. Audi bulletin 2081251 (2025-26 A5, A6, Q5, Q6 e-tron) asks for a report when U017E00 and U017F00 come with a proactive occupant protection fault message. Stellantis calls the U017E partner seatbelt sensor 1 in PCM-update bulletins for the 2021 300, Charger and Challenger, there with a lit MIL.
Possible causes
- Connector at the belt retractor module in the pillar loose or damaged high
- New retractor with control module not coded or basic setting not done medium
- Harness damaged or wrongly routed (Jeep JL, shifter area) medium
- Software issue in the module or a listener such as the PCM (FCA 2021) low
Symptoms
- Warning message for pre-crash occupant protection
- Belt no longer pre-tightened during emergency braking
- Airbag lamp on; on some FCA models MIL as well
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U017E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.